Loading...
Loading...
Getting Started:Loading...
Loading...
Let's light some LEDs!
Loading...
Loading...
This mini eBook is adapted fromHYPERDUINO IDEAS
by
Dr. Nancy Smith
and
Aunt Goodiebags
Let's light one LED!
You will need these pieces from your kit:
HyperDuino Board
9 volt battery
and connecting clip
and connecting clip
1 Touch sensor
easy-connect cable
(GRAY connector)
easy-connect cable
(GRAY connector)
Funduino
(Arduino Uno R3)
(Arduino Uno R3)
and a Touchpoint
1 Easy-connect cable
with pre-attached LEDs
(Red or Blue LEDs and BLACK connector)
with pre-attached LEDs
(Red or Blue LEDs and BLACK connector)
The HyperDuino
and Funduino Uno
and Funduino Uno
1. The HuperDuino "piggybacks" onto the Funduino.
The tiny pins on the HyperDuino fit into the sockets on the the sides of the Funduino. Carefully line up the pins and ease the HyperDuino into the Funduino. Do not force it!
NOTE: The HyperDuino does NOT fit tight against the Funduino. There will be a small space between.
The Cables and Boxes
Note the little bump on the cable connector blocks on the multi-color ribbon cables.
This is the GRAY connector block.
There is also a bump on the BLACK connector.
This is the GRAY connector block.
There is also a bump on the BLACK connector.
The boxes have a slot.
The bump on the cables fit into the slot in the box.
The bump on the cables fit into the slot in the box.
NOTE: The WHITE box is labeled "TOUCH" and the BLACK boxes are LEDs 8-13 and LEDs 2-7. We will be using the TOUCH and LEDs 2-7 boxes right now.