As part of the STEAM UP project, we tried and built a balloon powered car. The entire procedure is explained in several steps.

Balloon powered car experiment

Clouds pattern

After putting the caps on each side, we checked the balance of our toy car.

            STEAM UP<br/><strong>Balloon powered car</strong><br/>

We put a stick for skewers through the holes.

We added one cap to each end of the stick.

We repeat the process and we drilled the holes on both sides and put one cap on each side.

We also checked the balance of our toy car again.

We stuck a straw and a balloon on the car with duct tape.

We started playing with our very own balloon (air) powered car. :)

First, we prepared all the necessary materials.

Then we drilled two holes opposite each other with a screwdriver.

Safari may block some audio or video from playing automatically and ‘read to me’ will skip these. You can configure this in Safari’s preferences.